MAPED
MATT-CUTTING SYSTEM
A well designed small-scale
matt-cutting system designed along the principles of a full scale matt-cutting
machine, and producing true 45° bevels. It is capable of producing
results indistinguishable from the best professionally cut matts, and
we have found no better unit than this.
The Profila ruler contains a channel
along its length, into which the lugs on the Maped cutter locate. The
board to be cut is first marked up with image size, and then cutting guide
lines 2.5cm inside this. These lines provide locations for the edge of
the ruler, and starting and stopping points for the cutting head. No great
force is needed to operate the cutting head, and cutting is preferably
done with a series of cuts, sinking gradually deeper. If cutting is inadvertently
made too shallow, the original cut can be easily re-located and finished
off. If the board has been properly marked, the centre of the matt should
fall out with no over-cutting. It is usually best, though, to undercut the corner by a fraction, and then chip out the last threads holding the centre using a hand held blade.
A 90° cutter for vertical matts is
also available.
See below for Profila rulers, which are heavy duty with
2 rubber strips for good grip, as well as a steel rod let into one face for trimming
with a knife.
There are now 3 kits combining heads and rulers which offer a budget price for the package. Bear in mind the rulers sold in these have only one rubber grip, and no cutting edge. If you need the heavier duty rule, buy the cutting head, and a Profila ruler from the list below.
The 'Maped Plus' kit is a new design embodying built in start and finish stops and a simplified marking up system.
Both 45° + 90° cutters and rule are included. The heads are not compatible with the standard system, although the refill blades used are the same.
